Fluxcore Welders - TREO STAFFING LLC
Pascagoula, MS 39567
About the Job
- Weld Components in flat, vertical, or overhead positions.
- Clamp, hold, tack-weld, heat-bend, grind or bolt component parts to obtain required configurations and positions for welding.
- Select and install torches, torch tips, filler rods, and flux, according to welding chart
- Specifications or types and thicknesses of metals.
- Ignite torches or start power supplies and strike arcs by touching electrodes to metals being welded, completing electrical circuits.
- Connect and turn regulator valves to activate and adjust gas flow and pressure so that desired flames are obtained.
- Determine required equipment and welding methods, applying knowledge of metallurgy, geometry, and welding techniques.
- Monitor the fitting, burning, and welding processes to avoid overheating of parts or warping, shrinking, distortion, or expansion of material.
- Operate manual or semi-automatic welding equipment to fuse metal segments, using processes such as flux-cored arc
- Chip or grind off excess weld, slag, or spatter, using hand scrapers or power chippers, portable grinders, or arc-cutting equipment.
- Remove rough spots from workpieces, using portable grinders, hand files, or scrapers.
- Prepare all material surfaces to be welded, ensuring that there is no loose or thick scale, slag, rust, moisture, grease, or other foreign matter.
- Preheat workpieces prior to welding or bending, using torches or heating furnaces.
- Guide and direct flames or electrodes on or across workpieces to straighten, bend, melt, or build up metal.
- Detect faulty operation of equipment or defective materials and notify supervisors.
- Clean or degrease parts, using wire brushes, portable grinders, or chemical baths.
- Cut, contour, and bevel metal plates and structural shapes to dimensions as specified by blueprints, layouts, work orders, and templates, using powered saws, hand shears, or chipping knives.
- Repair products by dismantling, straightening, reshaping, and reassembling parts, using cutting torches, straightening presses, and hand tools.
- Fill holes, and increase the size of metal parts.
- Check grooves, angles, or gap allowances, using micrometers, calipers, and precision measuring instruments.
- Operate metal shaping, straightening, and bending machines, such as brakes and shears.
- Hammer out bulges or bends in metal workpieces.
- Dismantle metal assemblies or cut scrap metal, using thermal-cutting equipment, such as flame-cutting torches or plasma-arc equipment.
- Gouge metals
Source : TREO STAFFING LLC
