Mold Setter - Berry Global, Inc

1. Check mold changing schedule to make sure molds are ready to go in.

2. Remove and re-hang breakdowns.

3. Change mold according to the mold setting and removal guidelines.

4. Clean machine and part drop area after mold change.

5. Maintain stat boxes in operational order

6. Make sure knock-out bars going into the mold are the same length and not stripped out.

7. Make sure all molding setting areas are straightened up and clean.

8. Inspect and repair water and air hoses.

9. Maintain electric for trucks, checking water in batteries and making sure batteries are fully charged.

10. Maintain and enforce all company safety, environmental and department of health requirements.

11. Enforce plant safety during Mold Changes

12. Shut Machines down to do mold changes

13. Stop Traffic while transporting Molds

1. High School diploma / GED equivalent.

2. Basic trouble shooting skills and proven ability to apply that knowledge.

3. Ability to lift 50 pounds a minimum of 4 times per mold change.

4. Ability to lift 20 lbs. over shoulder height a minimum of 10 times per mold change.

5. Ability to climb on and off a forklift safely and without assistance at a minimum of 16 times an hour.

6. Ability to safely operate a forklift in high traffic, low clearance areas while not posing a safety risk to others. Must not be at risk of sudden alterations in consciousness.

7. Hearing sufficient to recognize and respond to shouted warnings, alarms and horns on forklifts.

8. Ability to work at heights (with or without fall protection). Must not be at risk of sudden alterations in consciousness.

9. Able to climb ladders safely and without assistance for a minimum of 12 times per mold change. Must not be at risk of sudden alterations in consciousness.

10. Verbal communication adequate to use a radio and or paging system to contact other co-workers in other areas of the complex.

11. Able to use both hands for effective manipulation of tools/parts.

12. Able to work overhead or in awkward positions on a frequent basis.

13. Ability to push/pull loads of approx 60 lbs at a minimum of 6 times per mold change.

14. Stereoptic vision of 20/40 or better and peripheral vision of 70 degrees or greater and ability to read 10-12 point font at a distance of 12-18 inches.

15. Able to stand/walk for 7 hours of an 8-hour shift