Welder 1st shift plant 1 - Husky Rack & Wire

Please visit our career page by following the link below and find out about job opportunities with Husky Rack and Wire.[http://huskyrackandwire.com/careers/](http://huskyrackandwire.com/careers/){target="_blank"} Hours: Monday - Thursday 5:00am to 3:30pmwith mandatory OT on Fridays and Saturdays based on a business need

Job Summary:

Perform various duties to set welding fixtures, assemble and clamp parts and MIG weld joints on a variety of parts and assemblies following standard practices and procedures

Essential Job Requirements: - Mig welding experience, formal Mig welding training or able to complete and pass a welding test

- Ability to read a tape measure - Good attendance record

Essential Job Functions:

1

Adjust locating rails and stops for length, width of assembly and position of components to be welded

Use assembly components as setting gauges and use tape to measure within 1/16 inch

Refer to charts and sketches for set up information

2

Place posts, horizontal and diagonal braces, connectors, foot plates or other components into fixture, rotate braces using special hand tool, position parts to stops and clamp in place using "C" clamps, quick clamps, air operated or other clamping devices

3

MIG weld bead or tack all accessible joints as necessary, remove or release clamps and remove assembly to position for complete welding.

4

Manually weld connectors to beams or touch up weld from auto beam welder as required

5

Make necessary adjustments to wire feed, heat and gas flow

6

May use gas torch to cut notches and heating parts for bending as required

7

Obtain material on rack truck from storage area or from rolling mills

Get welded wire as required from storage, transfer to work area, mount on reel and assemble to wire feed mechanism over head using helper to hold feeder in position

8

Maintain the work area in a clean and orderly condition

9

Detect equipment malfunctions, defective materials, unusual conditions to supervisor

Maintain equipment and work areas in clean and orderly condition

Observe all safety rules, regulations, and practices

Perform other similar or related duties as assigned or instructed by supervisor [Evaluated Revised Revised [AHS 9/11/85 AHS 7/92 RGM 5/97 [THE DESCRIPTION ABOVE REPRESENTS THE MOST SIGNIFICANT DUTIES OF THIS POSITION BUT DOES NOT EXCLUDE OTHER OCCASIONAL WORK ASSIGNMENTS NOT MENTIONED, THE INCLUSION OF WHICH WOULD BE IN CONFORMITY WITH THE FACTORS ASSIGNED

EEO/AA/M/F/Vet/Disability Employer ]{latha",sans-serif"=""}]{latha",sans-serif"=""}]{latha",sans-serif"=""}